Cisco Catalyst 4500 Instructions page 13

#############################################################
##############################################################
######################################################################### [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (TM) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(11b)EW,
EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 14-May-02 13:31 by hqluong
Image text-base: 0x00000000, database: 0x00B1C1F8
cisco WS-C4006 (MPC8245) processor (revision 5) with 262144K bytes of memory.
Processor board ID FOX04169082
Last reset from Reload
32 FastEthernet/IEEE 802.3 interface(s)
18 Gigabit Ethernet/IEEE 802.3 interface(s)
467K bytes of nonvolatile configuration memory.
Uncompressed configuration from 1730 bytes to 4359 bytes
Press RETURN to get started!
00:00:21: %SYS-5-CONFIG_I: Configured from memory by console
00:00:21: %LINK-3-UPDOWN: Interface GigabitEthernet1/2, changed state to up
00:00:21: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (TM) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(11b)EW,
EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 14-May-02 13:31 by hqluong
00:00:21: %SNMP-5-COLDSTART: SNMP agent on host Switch is undergoing a cold start
00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/2,
changed state to down
Switch>
Switch>
12. Le commutateur a démarré avec l'image qu'il a reçue du serveur TFTP lorsqu'il la copie
dans la DRAM. L'image n'est pas encore copiée sur le bootflash :, et par conséquent elle
doit être copiée à nouveau dans le bootflash : ou slot0:. Émettez la commande enable , et
fournissez le mot de passe si nécessaire pour entrer en mode EXEC, comme le montre cet
exemple :
Switch>enable
Password:
Switch#