ARIETE 2775 Mode D'emploi page 13

How to empty the dust container (E)
- Press the release button and at the same time take out the dust container (E) using the handle (A)
(Fig. 4).
- Empty the dust container (E), opening the lid with the release button (Fig. 5).
IMPORTANT: To empty the container and prevent any dirt from leaking out, we recommend first
placing it inside a plastic bag and emptying it there.
- To clean the container (E) fully, it is necessary to disassemble it completely, as described here
below:
- remove the whole filter by turning it anticlockwise (Fig. 6);
- take the lid off the Hepa filter (Fig. 7).
IMPORTANT: Wash the filter in clean water without soap or detergents. It is advisable to clean the
filter at least every 6 months or in any case, when suction is visibly reduced.
- The filter needs to be re-assembled before the appliance can be used again.
- Insert the filter into the container (E) and lock it into place by turning it clockwise.
- Refit the complete dust container (E) onto the body of the appliance, pressing gently until it clicks
into place, making sure that the air intake on the container has fitted perfectly into its housing in
the appliance bottom (Fig. 8).
Cleaning the air outlet filter
This filter cleans the air one last time before it leaves the vacuum cleaner. To clean the filter proceed
as follows:
- Use the lever to remove the small hatch on the back of the appliance (Fig. 9).
- Clean the filter in cold water and leave it to dry (Fig. 10).
- Refit the clean (or new) air outlet filter into the grid and return this to the appliance, pressing it down
until it clicks into place.
WARninG: only wash the filter in clean water, without using soap or detergents.
WARninG: it is advisable to clean the filter at least every 6 months or in any case, when suc-
tion is visibly reduced.
Cleaning the vacuum cleaner
The casing, dust container and filter seats can be wiped with a damp cloth if necessary. No liquid
must enter the vacuum cleaner in the process. Never use heavy-duty cleaning substances (stain
removers, thinners) because they can corrode the plastic surfaces. Only put the plug back into the
mains socket when you are sure that all parts are thoroughly dry.
IMPORTANT: Do not lubricate or oil any rotating parts, since this could cause dirt and fluff to stick
even further
Cleaning the brushes
While the appliance is switched on, move your hand between the bristles on the brush to free them
of any trapped dust, which will then be sucked into the cleaner.
- 11 -
EN