Connection And Operation - Dantherm TH 2 Manuel D'utilisation Et De Maintenance

7. CONNECTION AND OPERATION

WARNING: Carefully read the "SAFETY INFORMATION" before switching on the heater.
NOTE: If the room temperature is higher than the temperature set on the thermostat, the heater does not
go on.
►►►ROOM THERMOSTAT --MODEL 1-- (PIC. 1):
►►7.1. OPERATION:
►7.1.1. Connect the power cable of the room thermostat to the mains (PIC. 4).
►7.1.2. Connect the power cable of the heater to the room thermostat (PIC. 5).
►7.1.3. Turn on the heater and set the desired temperature by turning the knob (PIC. 6).
►►►ROOM THERMOSTAT --MODEL 2-- (PIC. 2):
►►7.2. OPERATION:
►7.2.1. Remove the plug connected to the heater and connect the room thermostat to the heater (PIC. 7).
►7.2.2. Turn on the heater and set the desired temperature by turning the knob (PIC. 6).
►►►DIGITAL ROOM THERMOSTAT --MODEL 3-- (PIC. 3):
►►7.3.1. THERMOSTAT SETTING:
This menu allows you to set and adjust the operating parameters of the room thermostat.
Access the menu as follows:
►Press the buttons "+" / "-" (D PIC. 8) simultaneously for a few seconds, and "C.O.S.t." will appear on the
display (A PIC. 8).
►Press "SET" (C PIC. 8) to move around the menu, until the desired setting appears on the display (A
PIC. 8). Refer to the table below as a reference [press the buttons "+" / "-" (D PIC. 8) to set the correct
setting]:
PARAMETER PRESET
diFF 0,2 °C
tEnP °C
Ad.tE 0.2 °C
rY.OC 1
►Press "SET" (C PIC. 8) to confirm the setting.
►Press and hold "SET" (C PIC. 8) for a few seconds to exit the menu.
►►7.3.2. OPERATION:
►Press "SET" (C PIC. 8) to enter the temperature setting menu.
►Press the buttons "+" / "-" (D PIC. 8) to set the desired temperature.
►Press "SET" (C PIC. 8) to confirm and exit the menu.
NOTE: During heater mode, the "FLAME (HEATING ON)" or "SNOW (COOLING ON)" (B PIC. 8) LEDs
light up to indicate the status of the room thermostat.
►►7.3.3. DISPLAY OF RECORDED TEMPERATURES:
►Pressing "+" (D PIC. 8) displays the maximum temperature recorded.
►Pressing "-" (D PIC. 8) displays the minimum temperature recorded.
NOTE: Reset the log by pressing and holding "+" (D PIC. 8) for a few seconds and "CLEA" will appear on
the display (A PIC. 8).
DESCRIPTION
Sets the "ON/OFF" differential
Unit of measurement "°C" / "°F"
Correction of the temperature probe
Type of probe (Correct setting 1)
en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh