Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
2. Install the AAA battery as shown in the diagram below
3. Place the filler material by hand. Do not dump the bag into the burner area, or directly onto the burner
to avoid clogging the burner with dust. Position the filler material across the burn area to a level 1 inch
(2.54cm) above the burner tube above the burner. Make sure that you do not block the igniter housing
with filler to ensure proper ignition and operation.
If using glass filler Real Flame suggests placing a layer of lava rock down first around the burner then
adding glass on top of that to improve airflow to the burner.
Lava Rock and Glass Filler Warning
1. Do not overfill the burner area with rock or glass filler; use only the specified amount. The depth of the
filler should not be more than 1 inch (2.54 cm) above the burner tube. Only Real Flame filler products
have been certified and tested for safe use with this Real Flame fireplace. Using other filler material
may result in increased popping and cracking or increased carbon monoxide emissions.
2. Do not light or use this fireplace if the filler is wet. Ensure filler is completely dry before lighting.
Intense heat can cause wet filler to explode and hit someone causing property damage, serious
injury, or death.
3. Keep away from the fireplace for at least 20 minutes during initial start-up as filler could retain
moisture from manufacturing and shipping.
-
+
8
Publicité
