Installation - VINCENT SA-96 Manuel D'utilisation

Set up the cable links in a sequence as follows. Connect the power cable between device and power
supply only after all other connections have been made.
Protective caps
Prior to the first installation the pro-
tective plastic caps must be removed
from all the connections used at the
rear of the unit.
RCA connections
Mechanically identical RCA plugs are available
for input and output connections. Make sure that
you do not get these connections confused during

installation!

Make sure that you do not mix up the analogue
connectors for right and left. The RCA plugs for
these are mostly colour coded as follows: red for
the right channel, black or white for the left channel.
Contacting the middle pin of the RCA plugs with
the outer ring of the RCA chassis jack may lead to
damages to the main amplifier if it is switched on!
To avoid this hazard, connect or disconnect only in
switched-off state and more than one minute after
deactivating!
INSTALLATION
DURING INSTALLATION PLEASE
OBSERVE THE FOLLOWING ADVICE:
1
O UT PU T
Cable connections
2
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
OU
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
Vincent
31