Looking Outside - Marmitek DOORGUARD 470 Guide Utilisateur

6 LOOKING OUTSIDE

STANDBY mode
Press the monitor button (4).
The image of the first camera
is displayed.
The display stops
automatically after
60 seconds.
Press the intercom button (5).
You can now start a
conversation via the camera.
Press the disconnect button
(7).
If you only use 1 camera doorbell, you can also go to standby by pressing
the disconnect button (7).
If the monitor function is active on the monitor and someone rings the
doorbell, the monitor will automatically switch to the image of this
doorbell's location.
DoorGuard 470
Press the monitor button (4)
again.
The image of the second
camera is displayed.
Press the monitor button (4)
again to enter standby.
Press the door opener button
(6) to activate it.
Standby
15