Using The Monitor; Monitor Display Settings; Call Tone Menu; Image Menu - Marmitek DOORGUARD 470 Guide Utilisateur

4.3

Using the monitor

Follow these steps to connect your monitor to the camera doorbell:
x
Connect the supplied 4-wire cable to the doorbell.
x
Connect the other end to your monitor, DOOR1.
x
Connect the adapter to the power jack.
Supply adapter with voltage.
The monitor will now start up.
After a few seconds you will hear a 'beep', indicating that the system has
booted.
4.4

Monitor display settings

On the monitor, press button 8 briefly to activate the display settings.
By rotating the button downward, you cycle through the 5 main menus.
Make your selection by briefly pressing the button.
In the sub menu, you can make your selection by rotating the button down
or up and briefly pressing it to confirm the selection.
You can then adjust the selection again by turning the button up or down
and briefly pressing it to confirm the adjustment.
4.4.1

Call tone menu

x
Select call tone: Choice of 16 melodies.
x
Call tone duration: can be set between 5 and 30 seconds.
x
Call tone volume 1, 2 and 3: You can set the call tone volume for 3
time spans.
For example, loud during the day, a little softer in the evening and
very soft at night.
4.4.2

Image menu

x
Language: EN, DE, FR, ES, IT or NL
x
Clear
x
Colour
x
Contrast
4.4.3

Time menu

x
Time: setting date and time
x
Key tone: turn on/off key confirmation tone
x
Reboot: reboot monitor
x
Version: monitor firmware version
12 © MARMITEK