Rustic Planer Heads (Accessories); Systainer; Maintenance And Service - Festool HL 850 E Guide D'utilisation

10
11.1
HK 82 RF
HK 82 RG
HK 82 RW
0 mm
11.3
11.2
12.3
12.2
12.1
Rustic planer heads
(accessories)
The planer can also be used to create rustic
surfaces. Three rustic planer heads are avail-
able for this purpose:
• HK 82 RG: creates a surface with a coarse struc-
ture.
• HK 82 RG: creates a surface with a fi ne struc-
ture.
• HK 82 RW: creates an uneven, wavy surface.
The blades on the rustic planing head (HK 82
RF, HK 82 RG, HK 82 RW) protrude approx.
1.5 mm over the planer foot. When using
rustic planing heads on the planer, set the
cutting depth to 0 mm. Otherwise there is a
risk that the blades on the head will cut into
the planer foot and destroy the planer.
The cutting depth limiter (11.2) prevents the
cutting depth from increasing inadvertently
while planing work is performed.
Always attach the cutting depth limiter to the
planer before working with a rustic planing
head:
- Set the cutting depth on the planer to 0 mm,
- Attach the cutting depth limiter by inserting the
rotary knob (11.1) through the limiter and into
the threaded hole (11.3).

Systainer

Many Festool products are shipped in a
unique system container, called "Systainer".
This provides protection and storage for the
tool and accessories. The Systainers are
stackable and can be interlocked together.
They also can be interlocked atop Festool CT
dust extractors.
- Place one systainer on top of the other.
- Release all four latches on the lower systainer
by pulling back at their top edges (12.1).
- Slide all four latches upward (12.2).
- Snap all four latches back to their fl at position
(12.3) so they engage the stacking tabs of the
upper systainer.

Maintenance and service

Always disconnect the mains plug
from the socket before carrying out any main-
tenance work on the machine.
Any maintenance and repair work
requiring an opening of the motor housing
11