Publicité
Les langues disponibles
Les langues disponibles
Installation
6.4
Selecting the installing location
!
WARNING! Risk of injury
Move the device with at least 2 people.
Observe the following, when selecting the installation location:
• The ambient temperature should be in accordance with the climate class. Other-
wise the set internal temperature cannot be reached or maintained. This can also
be the case with extreme fluctuations in the ambient temperature.
The intended ambient temperature and the climate class can be found in the
technical data (see chapter "Technical data" on page 40) and on the data plate
of the device.
• The ground must be level and sufficiently stable to support the device when fully
loaded.
• The device must be positioned so that the plug is accessible.
• Note the information on the electrical connection (chapter "Connecting the
device to the power supply" on page 29).
• Do not install the device in an area with excessive moisture.
➤ Remove all the inner and outer packaging material before setting up the device.
6.5
Placing the device
I
NOTE
• Observe the device's dimensions and safety distances when install-
ing the device (fig. e, page 10 to fig. h, page 11).
• Ensure that the door can be opened completely and is not blocked
by other objects.
DE15F, DE24F, EA15F, EA24B, EA24F
1. Ensure that the door is locked when moving the device.
2. If necessary, tape the door with duct tape.
3. Position the device.
EA24D only
1. Fix the drawers with duct tape when moving the device.
2. Attach the anti-tip brackets on the floor (fig. i, page 12).
3. Position the device.
28
DE15F, DE24F, EA15F, EA24B, EA24D, EA24F
EN
Publicité
