Publicité
STEP 10
FIG. 12
Place template into cabinet and
position the front edge to where
the back of the door will be when
closed (See Figure 12) inset door
= set back the thickness of your
door, overlay door = place at the
front edge of cabinet.
Using an awl or pencil, mark
through the bold dotted screw
locations onto your cabinet floor.
Remove template when done.
Using your 3/32" drill bit, pre-drill
in all (8) locations making sure to
NOT drill through the cabinet floor
completely.
Lay your assembled slide set over
the top of the marked holes. Using
(8) #6 x 1" deep thread Phillips
head screws, attach the slides to
the cabinet floor through the gray
slide feet holes. Place your wood
frame with attached triggers on
top of the slides and push back
until you hear the "click" sound.
3
32
FIG. 13
FIG. 14
DOOR MOUNTING
Once the product is installed, you
will want to attach the cabinet
door for easy access. Loosen the
lock nuts (3/8" wrench) inside the
front wall of the unit to adjust the
brackets horizontally (See Figure
13).
Note: Make sure the door
brackets are lined up with the
thick portion of the cabinet door
(See Figure 14).
Mark screw locations
4
Customer Service: 800-626-1126 | rev-a-shelf.com
Publicité
