Publicité
STEP 6
Reattach the OXO sidecar to the
wood chassis by reengaging the
slides (See Figure 8).
STEP 7
Loosen the lock nuts (3/8" wrench)
and T-nut screws inside the front wall
of the unit and remove all the door
mount hardware (See Figure 9).
STEP 8
Slide the door mount brackets
onto the opposite side of the
wood chassis and fix in place
with the lock nuts, washers, and
T-nut screws you removed in the
previous step (See Figure 10).
STEP 9
Attach the slide triggers to the
bottom of the wood frame, using
(4) #6 x 1/2" pan head deep thread
screws, into the predrilled holes on
the same side as the door mount
brackets (See Figures 11A and
11B).
FIG. 8
FIG. 9
Lock nut
FIG. 10
FIG. 11A
Pre-drilled holes
INSTALLATION INSTRUCTIONS: OXO PULLOUT
FIG. 11B
3
Publicité
