Andis T-Outliner ORL Instructions D'origine page 6

16. This appliance is only to be used with the power
supply unit provided with the appliance.
17. This appliance is only supplied at safety extra
low voltage corresponding to the marking on
the appliance.
18. Keep the appliance dry.
SAVE THESE INSTRUCTIONS
REFER TO PAGE 2 FOR FIGURES.
UNIVERSAL AC/DC POWER ADAPTER
The unit/charging stand is equipped with a universal AC/DC power adapter.
Interchangeable input plugs are included for use in most countries around the world
(Figures A-F). Plugs may vary by model.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. While pressing down on button located on input plug, gently push up on plug until
it releases from power adapter (Figure G).
REPLACING INPUT PLUG:
1. To replace input plug, align tabs on the AC/DC power adapter with slots on input
plug (Figure G).
2. Gently push input plug into power adapter until it snaps into place.
OPERATING INSTRUCTIONS
• The battery is not intended to be replaced by the user.
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing the
battery.
• The battery is to be disposed of safely.
CHARGING TRIMMER USING CHARGING STAND
The AC adapter is intended for use with Andis model ORL lithium-ion trimmer battery
with a rated capacity of 4.5V
carton. Plug the AC adapter into a 120V AC outlet, or according to your local power
standards. Plug the adapter cord into the receptable on the back of the charging
stand (Figure H). Place trimmer in the charging stand.
6
1.2A. Remove the trimmer and AC adapter from the