Télécharger Imprimer la page

Andis T-Outliner ORL Instructions D'origine page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
The ON/OFF switch on the trimmer must be in the OFF position for the battery to
charge. The blue light on the trimmer will fade in and out while charging. Note that
the trimmer can be removed at any time during the charging cycle without harming
the trimmer or battery. Once the battery is fully charged, the light on the trimmer
(Figure I) will turn solid blue.
The trimmer has not been charged at the factory. Please charge the trimmer for
2 hours before the first use for maximum performance.
You can keep the trimmer plugged into the charging stand or adapter when not in
use. The charging stand or adapter will maintain the battery at full charge. We
recommend that the charging stand or adapter be unplugged if the trimmer won't be
used for seven or more days.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Make sure on/off switch on the trimmer is OFF.
3. Check to make sure adapter cord is plugged firmly into trimmer or charging stand.
Twist the adapter cord slightly to ensure good electrical connection.
4. If failure to charge still exists, return trimmer to Andis or an Andis authorized
service station for examination and repair or replacement.
CORDED OPERATION
If the trimmer powers OFF in the middle of a trimming job, the power cord can be
attached to continue use in corded operation. Plug the adapter cord directly into the
bottom of the trimmer (Figure J). When the trimmer is running with the adapter cord
attached, the blue light will remain solid ON to indicate strong power, even if the
battery is not fully charged. The trimmer will
charge at a slower rate while in use with the
cord attached.
TRIMMER INDICATOR LIGHTS
When the trimmer is running in a cordless
operation, a blue trimmer indicator light
means the battery has a strong charge.
When the light turns red (Figure I) the
battery level is low and should be recharged
as soon as possible.
If the trimmer automatically powers OFF,
move the power switch to the OFF position
and either charge in the charging stand or
plug in to cord to continue trimming. The
trimmer automatically powering off protects
the lithium-ion battery and is not a
malfunction. The trimmer will resume
normal operation when it is recharged or
plugged in to its power cord. The ORL
trimmer, by design, will run at full power
until the battery is fully depleted.
TRIMMER INDICATOR
LIGHT STATUS
Trimmer in Charging Stand
Fully Charged
Solid Blue
Charging
Blue Fade In and Out
Trimmer in Use (Cordless)
Full Charge
Solid Blue
Low Charge
Solid Red
Trimmer in Use (Corded)
Running
Solid Blue
OFF with Full
Solid Blue
Charge
OFF without full
Blue Fade In and Out
charge
7

Publicité

loading