Cleanmaxx VC1806 Mode D'emploi page 18

EN
ACCESSORIES
The floor nozzle (B) is suitable for both
carpets and hard floors.
The foot switch allows you to change be­
tween carpet and hard floor. For hard floors,
a brush is extended on the underside of the
floor nozzle. The floor nozzle can only be
used with the extension tube (C).
The combi nozzle (D) is a combination of
a small crevice nozzle and brush nozzle.
Press the release button on the brush
attachment and slide it upwards at the
same time to convert the crevice nozzle
into a brush nozzle (Picture F). The brush
attachment must be heard to engage in
place:
○ The crevice nozzle is suitable for
upholstery, cleaning the inside of cars
and for all nooks and crannies.
○ The brush nozzle is used for vacuuming
upholstery and textiles and for remov­
ing dust from delicate objects such as
picture frames, lamp shades, keyboards,
books etc.
The crevice nozzle (E) is ideal for places
which are hard to get to, such as corners,
crevices or recesses, upholstery and all
nooks and crannies that cannot be reached
with other nozzles.
The extension tube is intended to be used
with the floor nozzle for cleaning floors
(Picture D). In addition, it makes it easier to
reach ceilings and corners.
The wall mounting bracket (G) is suitable for
storing the device in a space­saving manner.
16
USE
Please Note!
■ Ensure that there are no larger, sharp
objects on the surface which is to be
cleaned.
■ Note the MAX marking of the dust con­
tainer. If the marking is reached during
use, empty the dust container. Empty
and clean the dust container after every
use. The filters must also be cleaned
regularly to prevent the motor from
being overloaded (see the "Cleaning and
Storage" chapter).
■ Switch off the device after you finish
cleaning each surface to increase the
operating time on each battery charge.
L
The device cannot be operated
when it is connected to the mains
power. Disconnect the connecting
cable (F) prior to use.
1. Select a nozzle (see the "Accessories"
chapter) and plug it into the suction
opening (8). For a longer reach, plug the
extension tube (C) in between.
To remove a nozzle or the extension
tube, pull the nozzle or the extension
tube out again.
2. Switch on the device and guide the
nozzle over the area to be cleaned.
To switch on at suction level 1, press the
On / Off switch (6) once. If it is pressed
for a long time (approx. 3 seconds), the
suction power increases to level 2.
3. To switch off the device, briefly press the
On / Off switch again.
L
To ensure optimum performance of
the device, empty and if necessary
clean the dust container after every
use (see next chapter).