en
Problem
Water on the surface
under the cup stand.
Service T DISC is
damaged or lost.
P
Fill tank lights up
even though there is
sufficient water in the
tank.
P
Q
7d and
7e are
flashing simulta neously
and it is not possible to
prepare drinks.
Q
Descale flashes
even though you are
using soft water.
Filter cartridge change
indicator is not working
anymore.
Cup lighting and LC-
display have turned off
Can I turn off the cup
lighting?
More Customer Service information is available online at www.tassimo.com
All manuals and user guides at all-guides.com
Possible!cause
Water from condensation.
The Service T DISC must
always be used for cleaning
and descaling processes.
The float in the water tank is
stuck.
There is a fault on the
machine.
Even soft water contains small
amounts of dissolved lime.
Please proceed as described
on page 26.
After 1 min. of inactivity,
machine automatically reverts
to stand-by mode to save
energy
–
Solution
Condensation may occur and
is not a fault. Remove it by
wiping with a cloth.
Look for the Service T DISC
in the storage compartment at
the back of the appliance.
The Service T DISC can be
obtained from the Bosch
customer service department
(article no. 611632, for contact
details, see page 194).
Clean the water tank and
ensure that the float can move.
Turn the machine off using
the on/off switch, wait
approximately 5 minutes and
turn the machine back on.
P
Q
7d and
7e are still
If
flashing, please contact the
TASSIMO careline.
08 00 032 88 33 (UK only).
Descale the appliance.
Special descaling agents can
be obtained from
www.tassimo.com, the Bosch
customer service department
(article no. 310967, for contact
details, see page 194) or from
your retailer.
If filter cartridge change
indicator is still not working,
please contact TASSIMO
careline.
To re-activate, please open
and close brewing unit.
No, the cup lighting is
automatically switched on and
off when machine is activated.
37
01/2013