Operation; Engine Start / Stop; Height Adjustment - Zipper Maschinen ZI-DRM 51 Manuel D'utilisation

Table des Matières

Les langues disponibles

13.2 Operation

Start the engine, if you have your mower mounted correctly:

Set throttle to the lower position. Pull the engine lever against the push handle. Pull the pullstarter-

handle until resistance is felt and then pull out quickly

rope guide back as soon as the engine starts. If the engine runs, set the speed with the throttle.

Let the engine lever going to stop the engine and blade

Your mower is equipped with a central height adjustment which 6 different height settings from 25 -

75 mm offers.

Turn off the engine and wait before changing the cutting height to the rotating parts are no

longer rotate.

To change the cutting height, push the joystick in the direction of the wheel. Turn to the left to reduce

the cutting height, turn clockwise increases the cut height. All wheels will be at the same height of the

cut. To adjust the front wheel of the average height, loosen the wing nut, pull out the axle and adjust

the wheel to the desired position. After fix the axle again.

Note: The cutting height can be chosen so that the blade on uneven surfaces do not touch the

ground! Mowing to low cutting adjustment should be performed only on a level, and plan lawns.

ZIPPER MASCHINEN GmbH

www.Zipper-Maschinen.at

ZI-DRM51

WARNING! Keep hands and feet away from rotating parts.

CAUTION: Do them at no time changes to the adjustment of the

machine without shutting off the engine before.

by.

Run the pullstarter-handle slowly to the

OPERATION

Table des Matières