Cleaning; Disposal - Zipper Maschinen ZI-DRM 51 Manuel D'utilisation

14.9 Cleaning

Clean the machine and the working attachment from soil, dust, grass, chips, and small twigs, etc.
Clean the machine housing with a wet cloth and a mild cleaning solution.
Put on all coatless flats a thin coat of oil.
The usage of solvents, aggressive chemicals or scouring agents damages the
machine housing.

14.10 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old
Please note that a return should always be in the original packaging. By
this measure, accidental damage and their often contentious regulation are
effectively avoided. Only in the original box your device is optimally
protected and thus secured a smooth machining.
15 TROUBLE SHOOTING
Trouble
Engine will not start
Rough running,
vibrations
Engine runs irregular
Low quality cut
Mower does not collect
properly
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-DRM51
NOTICE
NOTICE
Possible cause
 Engine brake lever pressed
correctly?
 cable for engine brake adjusted ?
 plug or plug cap defect
 fuel tank empty
 Loose engine screws
 Loose blade screw
 damaged or unbalanced blade
 friction clutch worn
 air filter dirty
 bent / damaged throttle cable
 spark plug dirty
 blade is blunt
 cutting height too low
 cutting height set too low with high
grass
 blade worn
 catcher fabric clogged
N O T I C E
TROUBLE SHOOTING
Solution
 press/pull brake lever
correctly
 check adjustment
 clean or replace plug or cap
 refuel
 tighten screws
 check blade tightening
 balance or replace blade
 replace friction washers
 clean air filter or replace
 adjust / replace cable
 clean plug
 sharpen blade
 adjust cutting height
 adjust cutting height
 replace blade
 clean catcher or replace
35