Operation Setup - Zipper Maschinen ZI-BM870ECO Manuel D'utilisation

14

OPERATION SETUP

Remove spark plug cap before per-forming any adjustments or checks on
the machine to prevent accidental start up of the engine.
Cutting clutch distance adjustment
If the cutting clutch distance is too short, you can adjust the cutting clutch line to L (Fig.D1) or L
(Fig.D3) direction. If the distance is too long, you can adjust to re-verse direction.
Forward clutch distance adjust
If the forward clutch distance is too short, you can adjust the forward clutch line to L (Fig.D1) or L
(Fig.D2) direction. If the distance is too long, you can adjust to re-verse direction.
Let this adjustments be performed by trained persons if you do not have the required technical
abilities.
Handlebar height adjustment (Fig.D4)
To adjust the handlebar height, loosen the bolts1 on the two side, select the appropriate height and
retighten the bolt.
Cutting height adjustment (Fig.D5)
Steplessly adjustable cutting height up to approx. 6cm!
Loosen nut1 and 2, move the skids to the required height and retighten the nuts.
Both skids must be set to the same height!
Cutting bar adjustment (Fig.D6)
After a certain usage time, the upper blade and down blade of the cutting bar become loosen, you can
take out some pieces of washers1. Four positions must be set to the same thickness!
Fill up motor oil
See E1, remove oil tank cap 3. Fill in suitable motoroil up to lower edge up oilfiller neck.
MOTOROIL TO BE USED:
High Quality SF15W-40 motor oil for 4-stroke engines.
Refuelling
Use standard commercially available unleaded petrol/gas.
Do not use petrol/oil mixtures.
Take care when refuelling that no foreign particles get into the fuel tank.
After refuelling tighten the tank cap again.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BM870ECO
ATTENTION
OPERATION SETUP
23