Tyco American Dynamics illustra 600 Guide De Démarrage Rapide page 6

Micro SD
Default

Video System: PAL / NTSC system switch. Default is NTSC. Use a suitable small tool to operate
the switch.
Note:
After switching the video system mode from NTSC to PAL or vice versa, you have to restore
defaults to apply the changes. You can do this by either of these methods:
1. Press the Default button on the camera and release within 4 seconds to restart the camera.
2. Enter the web-based illustra utility > System > Firmware and press the Factory Default
button.

Micro SD: Micro SDHC card slot.

Default:
-
Factory Default: Press and release within 4 seconds to restart the camera and restore factory
defaults, excluding IP settings*.
-
Hardware Factory Default: Press for more than 5 seconds and then release to restart the
camera and restore factory defaults, including IP settings*.
*The IP settings include DHCP, IP address, subnet mask, default gateway, DNS and HTTP
port, which are configured under Network > IP & Ethernet in the illustra utility .

Reset: Using a paper clip or thin object, press the button for at least one second and release to
restart the camera.

Video Out: Analog video out RCA jack. Connects to video in connector of a monitor.
All manuals and user guides at all-guides.com
1. Camera Installation
Video System
Video Out
Reset
5