Publicité
Les langues disponibles
Les langues disponibles
Starting the engine. If you pull out the choke knob (at the back-right of the rear
handle) to the point of the arrow, you can set the starting mode as follows:
• First-stage position – starting mode when the engine is warm.
• Second-stage position – starting mode when the engine is cold.
Position: Upper-right of the air cleaner cover
H
The screw under the "H" stamp is The High-speed adjustment screw.
L
The screw under the "L" stamp is The Slow-speed adjustment screw.
T
The screw at the left of the "T" stamp is the Idle adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and activated
(black arrow).
Position: Front of the chain cover
If you turn the rod by screwdriver follow the arrow to the "MAX" position, the
chain oil flow more, and if you turn to the "MIN" position, less.
Position: Bottom of the power unit
3.4.2- Symbols labeled on machine
Read the instructions manual before operating the machine
Read, understand and follow all warnings.
This saw is for trained tree service operators only.
Carefully and thoroughly read the notice before use.
Wear head, eye and ear protection.
Use appropriate personal protective equipment for your head, eyes, face, and
limbs (foot, leg and hand-arm).
Warning! Danger of kickback.
Use the chain saw with two hands.
Protect the machine from rain. Do not expose the machine to rain or leave the
machine outside under the rain.
Do not use the product in bad weather, in the rain or during inclement weather,
strong winds, during cold or hot weather, or fog or other conditions that reduce
visibility. Working in bad weather leads to increase fatigue and risk of
accidents, etc.
Never touch hot surface.
Recoil start by pulling the cord
Publicité
