Publicité
Les langues disponibles
Les langues disponibles
PROCOM 2 or CYCLIC 2020 regulation - SEC 7HC air treatment type
MEANING OF THE PICTOGRAMS USED IN THIS MANUAL
Symbols are used in these instructions to help you understand them and to indicate
particular points which you need to act upon or consider. Those symbols are:
Reading symbol: to refer to the operator manual / instructions manual.
Warning symbol: This symbol means that failure to observe this point could lead to
injury and possibly damage to the machine. It serves as a special reminder about
regulations and/or the correct implementation of certain precautions.
Danger symbol: This symbol represents the DIN 4844 symbol (hazard warning); it
warns of a hazard which could result in death or injury, along with damage to the
machine. This symbol must be observed by all personnel working on this machine.
Regulations on safety in the workplace must be observed.
Environmental protection symbol: This symbol serves as a reminder to sort waste
during maintenance operations, to store it in a safe place, and to dispose of it with
due care for the environment.
Dustbin on wheels barred of a cross symbol: This symbol indicates that the
equipment should not be thrown with domestic waste and is subject to selective
collection.
Non-ionizing radiation hazard symbol: This pictogram informs of a risk or a danger
related to non-ionizing radiations.
General remark:
If used in accordance with their intended purpose, units bearing the CE mark will satisfy the
essential requirements of directive 93/42/EEC, relative to medical devices and, where
necessary, to essential requirements of the directive 2014/68/EU, relative to pressure
equipment.
Those units, when installed in accordance with these instructions, comply with the
provisions of currently applicable European Directives and harmonized standards.
However, your attention is drawn to the fact that three units (compressors or gas backup)
must be present on each installation.
519015-15
HOSPITAIR CABIN (MV) – 11 & 15 bar
To ensure personal safety and to avoid any damage to equipment, it is
essential to follow the instructions contained in this document and any
other documentation provided with the device, and particularly the
instructions on "Safe Practice".
1
INTRODUCTION
We strongly advise you to read these installation instructions, before first
switching on your air unit. The damage that could be caused by setting the
machine up or installing it incorrectly would not be covered by our
guarantee.
1.1 Specification plates
In order to simplify any future requests for spare parts or further information about your
compressed air plant, we advise you to copy onto this page the specifications written on
the plates fixed to the compressed air plant, as soon as you receive your machine.
Consult the copy of the specification plate fixed to the compressed air plant in fourth of
cover.
Medicinal air plant HOSPITAIR CABIN
Model
Regulation type
Serial number
Date of fabrication
Power of the plant
Power supply
Maxi. Pressure
Fluid group
Air treatment unit
Type
Model
Serial number
Date of fabrication
Power supply
Maxi. Pressure
Fluid group II
II
SEC 7HC
16 bar
18
Publicité
