Meec tools 014214 Mode D'emploi page 46

EN
SHARPENING THE LINE BLADE
1. Remove the line blade (A) from the guard
(B) by undoing the screws (C).
FIG. 14
2. Put the line blade in a vice and sharpen it
with a flat file. Make sure to maintain the
angle of the edge.
3. Refit the line blade on the guard.
REPLACING THE TRIMMER LINE
FIG. 15
STORAGE
• Clean the clearing saw well after use and
check that it is in good condition and that
no parts are missing or damaged.
• Replace or repair any damaged parts. Store
the clearing saw in a dry place with the
blade guard fitted.
• Clean the line spool at the end of the
season, and if necessary replace.
46