Publicité
Les langues disponibles
Les langues disponibles
EN
Fitting the trimmer head
Put the hex key in the hole to lock the fastener,
put the trimmer head on the axle and turn the
trimmer head clockwise to firmly screw it on.
FIG. 5
WARNING!
Always check before use that the trimmer
head is fitted correctly.
HOW TO USE
FUEL
WARNING!
•
Risk of personal injury.
•
Petrol is highly flammable and can in
some circumstances be explosive.
•
Switch off the engine and allow it to cool
before refilling with fuel.
•
Follow all the safety instructions for
handling fuel.
•
Always refuel before use.
NOTE:
•
The recommended mixing ration is 40:1
– 40 parts fuel to 1 part oil.
•
Mix the fuel with good quality 2-stroke
oil, intended for air-cooled 2-stroke
engines.
Filling
1.
Shake the container with the fuel mixture.
2.
Place the clearing saw on a level, stable
surface with the fuel cap facing upwards.
3.
Clean the filler cap and the area around
the opening to avoid contamination
entering the tank.
4.
Carefully open the filler cap so any
overpressure is relieved. Use a funnel and
do not overfill.
FIG. 6
5.
Carefully fill up with fuel. Avoid spilling.
44
6.
Replace the filler cap and tighten firmly.
7.
Wipe off spilled fuel and allow any fuel
residue to evaporate before starting the
engine.
NOTE:
•
Never use oil intended for 4-stroke
engines or water-cooled 2-stroke
engines. This oil can contaminate the
spark plug and exhaust port, or cause
the engine to seize.
•
Fuel mixed with oil that has stood for
more than one month can contaminate
the carburettor and prevent the engine
from working properly. Store leftover
fuel dark and cool in an air-tight
container.
•
Switch off the engine before filling up
with fuel. Never fill up with fuel when
the engine is running or hot. Fire risk.
STARTING THE TRIMMER
1.
Put the power switch in the ON position,
press the throttle control B, throttle
control A and the safety catch, so that
the throttle control A locks in half-pressed
position.
2.
Move the choke lever to OFF position.
FIG. 7
3.
Press the primer bulb at least 10 times
before starting the trimmer the first time.
FIG. 8
4.
To start the engine, pull the starter cord
slowly until it catches (10–15 cm) and
then pull it out fully a few times, to turn
the engine over and distribute the oil.
5.
Move the choke lever to ON position.
6.
Pull the starter cord until the engine
starts.
FIG. 9
7.
Press in throttle control A and B. When the
engine is idling use throttle control A to
control the speed.
Publicité
