Publicité
Les langues disponibles
Les langues disponibles
Inspired by life
EVO
Altus
Put all the connectors back in the CxSM
There are numbers beside the inputs of the
connectors; position the connectors in the
following way:
1: ST
(Stand-frame)
2: T
(Tilt)
3: B
(Back-rest)
4: L
(Leg-rest)
5: SW
(Support wheels)
Then place the R-net 2.0m cable and the R-net
cable for the joystick in the CxSM.
Remount the round-head bolt in the Altus arm.
PLEASE NOTE!
Don't forget to apply blue Loctite.
Then carefully check all the chair functions
Adjustment from 46 cm to 51 or 41 cm.
Remove the seat and back cushion.
Also remove the back plate by unscrewing the
M5x8 countersunk bolt. This is located in the
middle of the back plate.
Remove the arm supports and the cover cap of
the back-rest.
EN48
All manuals and user guides at all-guides.com
Remove the seat base.
Remove the colour strips on both sides of the
base rail. And move the belt if it is mounted in
front of the bolt.
Dismantle the base rails on both sides by re-
moving the countersunk bolts.
Unscrew the M10 hex-head bolt from the brack-
et so that the actuator comes loose.
EN49
Publicité
