Publicité
Les langues disponibles
Les langues disponibles
Inspired by life
EVO
Altus
Remove the 2 M6x16 cylinder bolts from the
arm-rest assembly.
First mount 2 fixing blocks.
Then position the 4 spacers, 2 on each side.
Don't forget to put back the 2 plastic sleeves.
Mount the last 2 fixing blocks.
Lastly, attach the left and right sides to each
other.
Replace the arm-rest assembly in the back-rest.
Remount the cover cap.
Replace the RIGHT ball joint.
EN38
All manuals and user guides at all-guides.com
It is very important that the parallel rod is fixed
at 16mm
PLEASE NOTE!
Screw in the ball joints on both sides.
The extension sleeve and the M10x20 Cylinder
head are located on the right side. Make sure
that you tighten everything properly.
Remount the arm supports.
PLEASE NOTE!
Don't forget to apply blue Loctite to the bolt.
Put all the connectors back in the CxSM
There are numbers beside the inputs of the
connectors; position the connectors in the
following way:
1: ST
(Stand-frame)
2: T
(Tilt)
3: B
(Back-rest)
4: L
(Leg-rest)
5: SW
(Support wheels)
Then place the R-net 2.0m cable and the R-net
cable for the joystick in the CxSM.
EN39
Publicité
