Fein Slugger JME USA 202 M Mode D'emploi page 23

Switching the gear setting (figure 13).
With the gear switch, you can select the
speed and thus the torque.
Adjust the gear setting only when the
machine is at a complete stop or when the
motor is running down.
Set the switch to gear 1 to work at low speed
with high torque. This setting is suitable for
drilling with large drill bit diameters and for
tapping.
Set the switch to gear 2 to work at high speed
with low torque. This setting is suitable for
drilling with small drill bit diameters.
JME HoleMaker –
III (**)
JME USA 202 M 1. Gear
(**)
JME USA 202 M 2. Gear
(**)
Max. capacity in steel
with up to 400 N/mm
– TCT (core drill bit)
1/2 in – 1 3/8 in
12 mm – 35 mm
1 1/16 in – 2 in
27 mm – 50 mm
1/2 in – 1 in
12 mm – 26 mm
Fig. 13
Max. capacity in steel
2
with up to 400 N/mm
– high speed steel
(core drill bit)
1/2 in – 1 3/8 in
12 mm – 35 mm
13/16 in – 2 in
21 mm – 50 mm
1/2 in – 13/16 in
12 mm – 20 mm
en
Max. capacity in steel
2
with up to 400 N/mm
– high speed steel
(twist drill bit)
1/4 in – 5/8 in
6 mm – 16 mm
5/8 in – 15/16 in
16 mm – 23 mm
1/4 in – 5/8 in
6 mm – 15 mm
23
2