Publicité
Les langues disponibles
Les langues disponibles
RS 200 M / RS 250 M / RS 300 M
3.7 Starting and Ending the Welding Process
• Determine the Coarse Adjustment ", Fine Adjustment" and Wire Feed Speed from the welding parameters
table of your machine according to the diameter of the wire you will use, the type of gas you will use and the
thickness of the material to be welded, and set your machine to these settings.
Wire Diameter
Material Thickness
Coarse Adjustment Range
Fine Adjustment
Wire Feeding Speed
Current
Voltage
• You can start welding after making sure that you comply with all safety rules and take the necessary
precautions.
• During welding, instantaneous welding voltage will be displayed in voltmeter and instantaneous welding
current will be displayed in ammeter.
When not welding, leave the torch in such a way that it does not touch the workpiece, the welding
• After you have finished working with the welding machine, allow the machine to cool down and turn the
pliers, the hood of the machine and the trigger does not remain pressed.
on / off switch to "0". Unplug the machine and close the gas cylinder.
www.magmaweld.com
Figure 18 : Welding Connections
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation
23
EN
Publicité
