Dirt Devil Tracker M613 Mode D'emploi page 39

4 Unpacking and assembling
4.3 Inserting the battery pack
1.
9
10
11
12
Danger of injury due to a non-original bat-
tery pack! Only insert the provided battery
2.
pack or an original replacement battery
pack purchased from us.
Danger of injury! Ensure that the appliance
is switched off (On/Off switch in the "0"
position), before you insert the battery
pack.
1. Ensure that the appliance is switched off
(On/Off switch in the "0" position).
2. Firmly push down the two pressure points
on the housing cover (Fig. 9/1.) and re-
move the housing cover (Fig. 9/2.).
3. Insert the provided battery pack. In this
process ensure the following:
- The sticker with the text "This side up"
- The contacts in the battery pack must be
- Let the battery pack first slide into the
- Leave enough space on the side of the
- Then press the battery pack into the bat-
- The battery pack must now rest evenly
4. Replace the housing cover and push it
firmly to close it. You will feel and hear the
cover snap into place.
NOTE:
At delivery the battery pack is not charged.
Consequently proceed as described under
Chapter 5, 'Charging the battery pack in
the appliance'.
WARNING:
WARNING:
must be facing up (Fig. 10).
able to engage in the apertures in the in-
sulation of the battery pack (Fig. 10).
battery compartment on the side with
the contacts (Fig. 11).
contacts that you do not crush the con-
tacts (Fig. 11).
tery compartment on the other side
(Fig. 12).
on the bottom of the battery compart-
ment (Fig. 12).
39