Stadler Form Albert Mode D'emploi page 12

or if it is not functioning correctly. disconnect the plug from the power
socket.
• the appliance shall be installed in accordance with national wiring regu-
lations.
Setup / operation
1. Place albert on a flat surface in the desired area. Plug the power cable
(16) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. you can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). there are 3 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. with the hygrostat (4) the desired humidity level can be set. Press on
the knob hygrostat (4) and change to desired humidity level with the
rotary control (10). humidity levels between 30 and 80% or continuous
running (CO in display) can be selected. a humidity level not higher
than 60% is suggested in general. If the dehumidifier reached the se-
lected humidity it will turn off and after that check the humidity level
in constant intervals by turning on the fan for a short time.
5. with the timer you can selecte precisely when albert should be run-
ning. the timer can be activated by pressing the knob timer on/off (6)
and the Led will be lit. If you press the knob again the timer will not be
activ and the Led will be off. to set the timer follow these instructions:
6. set the time: Press set (7) for 5 seconds and the symbol for hour is
shown blinking in the display, in addition the hours are blinking. now
you can choose the correct hour with the rotary control (10). If the
hours are correct, press set (7) again and the minutes can be adjusted
the same way. to finish press set (7) again.
7. set the timer: Press set (7) shortly and now you can set the timer when
the unit should turn on (timer on) and the timer when the unit should
stop (timer off), setting ist he same as time above. If the timer is ac-
tivated (blue Led is on), the dehumidifier will start and stop every day
at the set time (this is ideal for example to use the cheaper power
tarifs at night).
8. the swing mode (8) allows to distribute the dry air well in the room.
this mode is also suitable for example to dry clothes fast and efficient.
9. If you find the display and Led too bright (in a bedroom for example),
you may reduce the light intensity by pressing the night mode (9). the
fan will also be reduced in this mode to slow speed.
10. Once the water tank is full, the blinking symbol will appear on the
display and the dehumidifier turns off automatically. Please empty the
tank. Once you put back the tank, the unit will automatically restart.
11. defrost function: If the temperature in the room is below 16°C, the
dehumidifier automatically runs in defrost mode. this mode is shown
on the display and frost build up in the unit will be avoided during
dehumidification. It runs every 25 minutes during 7 minutes.
12. If desired, it is possible to connect a drainage hose to the unit for
permanent water drainage. In this case connect the hose (17) to the
unit through the hole in the back of the dehumidifier and place the
end of the drainage in a water outlet. Please make sure the end of the
hose is lower than the spout, otherwise the water will not drain and
flooding may occur.