Hilti SFC 14-A Mode D'emploi page 9

Symbols
Direct current
Drilling without
hammering
Location of identification data on the power tool
The type designation can be found on the type identification plate at the
base of the power tool and the serial number on the side of the casing.
Make a note of this data in your operating instructions and always refer to it
when making an enquiry to your Hilti representative or service department.
Type:
Generation: 01
Serial no.:
2 Safety instructions
NOTE
The safety rules in section 2.1 contain all general safety rules for power
tools which, in accordance with the applicable standards, must be listed in
the operating instructions. Accordingly, some of the rules listed may not be
relevant to this tool.
2.1 General power tool safety warnings
a)
WARNING
Read all safety warnings and instructions.
warnings and instructions may result in electric shock, fire and/or serious
injury. Save all warnings and instructions for future reference. The
term "power tool" in the warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power tool.
Printed: 20.05.2015 | Doc-Nr: PUB / 5071593 / 000 / 02
Rated speed under
no load
Revolutions per
minute
Failure to follow the
Revolutions per
minute
en
3