Hilti SFC 14-A Mode D'emploi page 18

Pull the battery out of the locked position (working position) and move it into
the first latching position (transport position).
Observe national and international transport regulations when shipping
batteries (transportation by road, rail, sea or air).
5.5 Belt hook
en
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the
operator. The belt hook can also be fitted to the other side of the power tool
for use by left-handed persons.
1. Remove the battery from the power tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.
6 Operation
CAUTION
The tool may get hot during use. Wear protective gloves.
CAUTION
When drilling and screwdriving, the grip of the tool may be deflected
laterally (the tool tends to pivot about its own axis).
CAUTION
To avoid injuries caused by the insert tool, wear protective gloves when
changing insert tools.
DANGER
Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
6.1 Setting forward or reverse rotation
NOTE
The forward / reverse switch is used to select the direction of rotation of the
drive spindle. An interlock prevents switching while the motor is running.
The control switch is locked when the forward / reverse switch is in the
middle position. Push the forward / reverse switch to the right (power tool
held in working direction) to select forward rotation. Push the forward /
reverse switch to the left (power tool held in working direction) to select
reverse rotation.
12
Printed: 20.05.2015 | Doc-Nr: PUB / 5071593 / 000 / 02
4
5