Publicité
Les langues disponibles
Les langues disponibles
Note 1:
If the transmitter is memorised in "Mode I" any key can be
pressed.
If the transmitter is memorised in "Mode II" the entire proce-
dure must be repeated for each memorised key to be deleted.
Alternatively this function can be performed using the O-Box
or O-View programming unit.
10 – ENABLING (or disabling) THE
RECEIVER FOR TRANSMITTER
MEMORISATION
This function enables the user to prevent memorisation of new
transmitters when the procedures "in the vicinity" ( factory
setting is ON) or with " enable code" ( factory setting is ON)
are used as described in this manual. To enable or disable this
function, proceed as follows:
01. Disconnect the receiver from the power supply and wait 5
seconds.
02. Reconnect the power and switch on by pressing the
receiver key until the relative led has completed the sig-
nals indicating the type of code stored in the memory
(see paragraph 5) and the procedure is activated, indicat-
ed by 2 short orange flashes. Then release the key.
03. (within 5 seconds) Press the receiver key repeatedly to
select one of the following functions (Warning! – on each
press of the key the Led changes colour to indicate the
currently selected function ):
• Led OFF = No lock enabled
• Led RED = Memorisation "in the vicinity" locked
• Led GREEN = Memorisation with "enable code" locked
• Led ORANGE = Both memorisation modes locked ("in
the vicinity" and with "enable code")
04. (within 5 seconds) Press any key of a transmitter already
memorised on the receiver to save the selected function.
Alternatively the lock (or unlock) function can be applied using
the O-Box or O-View programming unit.
EN
13
Publicité
