Publicité
Les langues disponibles
Les langues disponibles
Step 3：
A. Insert the foam tube (5) into the large hole on the height adjustment frame (4), then fix it with
screws (C) and flat washers (E). Put the foam (10) into the foam tube on both ends (5),
B. Insert the upper foam tube (5) into the casing hole of the presser foot, then secure it with screws
(C) and flat washers (E). Put the foam (10) into the foam tube (5) on both ends.
A. Using screws (C) and flat washers (E), attach the foot pressing device (6) onto the square tube,
which is at the lower end of the height adjusting lever (4).
B. Insert the assembled height adjusting lever (4) into the square tube on the backrest frame (3),
then use the quick-pull pin to pull the ring plug (G), so it goes into the corresponding hole according
to the height size requirements.
C. Using screws (A), flat washers (E) and nuts (F), fix the handrail (7) onto the side pipe of the main
bracket.
Note: After installation is complete, tighten all screws and ensure all latches are properly assem-
bled before using.
The following steps are for installing optional parts. Please check your product first, then follow
these steps bellow to install your product.
-10-
Publicité
