Toparc SAM-1A Manuel D'utilisation page 21

TITAN 400
TITANIUM 400
Connector cover plate:
NEOPULSE 400 G / 500 G
PULSEMIG 400 G / 500 G
Some configurations do not require all the kit's items.
4. SETTING UP THE DEVICE
INSTALLATION
WARNING
ELECTRIC SHOCKS CAN BE FATAL
Only experienced personnel authorised by the manufacturer may install the equipment. During installation,
ensure that the power source is disconnected from the mains.
Videos on how to set up the kit:
NEOPLUSE 320 C
PULSEMIG 320 C
NEOPULSE 400 CW
PULSEMIG 400 CW
Access to internal areas beyond those outlined in this video manual is prohibited and voids the warranty as well as all other forms of
support. Indeed, these interventions can be damaging to the power source's internal electronic parts and/or components.
SWO FEATURE (SAFE WELDING OFF)
The «Safe Welding Off» function mainly prevents the current or voltage source from starting. It acts directly on the power source
in a very short time.
This function is also used to safely stop the power source in the event of an emergency stop. This avoids a sudden power supply
interruption to the power source if a problem arises. It should be remembered that a break in the power supply downstream of a
loaded power source is dangerous and can damage the equipment.
I. Electrical safety
The «Safe Welding Off» function does not offer electrical isolation; therefore, before any work is carried out on the power source, it
must be electrically isolated by switching off the power supply and locally isolating the power source (padlock procedure).
SAM-1A
TITAN 400
98116
TITANIUM 400
99089GF
NEOPULSE 400 G / 500 G
PULSEMIG 400 G / 500 G
TITAN 400 DC
TITANIUM 400 AC/DC
EN
K0537GF
21