Publicité
Les langues disponibles
Les langues disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup, remove the grease filters from the hood by pushing down
filters out
.
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both
screws holding the damper assembly to the hood. Remove the parts bag captured behind
the damper assembly. Remove the damper assembly from inside the hood and keep the
screws for further use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.
B
C
SCR EWS
and tilting
DAMPER
ASSEMBLY
9
Publicité
