Checking supplied items
This product/
connection cables/
installation parts
• This product (×1)
• Power cord (×1)
• Pre out cord (×1)
• USB cable (×1)
• LCD screen mounting bracket (×1)
• Spacer (×1)
• Front bracket (×1)
Screws (nominal
diameter × length,
color)
• Flush surface screw (5 mm × 8 mm, Silver)
(×6)
• Binding head screw (5 mm × 8 mm,
Silver) (×6)
• Binding head screw with adhesive (4 mm
× 30 mm, Silver) (×4)
Connection
Precautions
• Binding head screw with adhesive (4 mm
× 12 mm, Silver) (×4)
• Binding head screw (4 mm × 5 mm, Black)
(×4)
• Machine screw (2 mm × 4 mm, Black) (×4)
GPS antenna/
installation parts
• GPS antenna (×1)
• Metal sheet (×1)
• Double-sided tape (×1)
• Clamps (×3)
Microphone/
installation parts
• Microphone (×1)
• Double-sided tape (×1)
Other items
• Manual(s) (×1)
• Warranty Card (×1)
Your new product and this
manual
• Do not operate this product, any
applications, or the rear view camera
option (if purchased) if doing so will
divert your attention in any way from the
safe operation of your vehicle. Always
observe safe driving rules and follow all
existing traffic regulations. If you
experience difficulty in operating this
product, pull over, park your vehicle in a
safe location and apply the parking brake
before making the necessary
adjustments.
• Do not install this product where it may
(i) obstruct the driver's vision,
(ii) impair the performance of any of the
vehicle's operating systems of safety
features, including airbags, hazard lamp
buttons, or
(iii) impair the driver's ability to safely
operate the vehicle.
In some cases, it may not be possible to
install this product because of the vehicle
type or the shape of the vehicle interior.
Important safeguards
WARNING
Pioneer does not recommend that you
install this product yourself. This product is
designed for professional installation only.
We recommend that only authorized
Pioneer service personnel, who have
special training and experience in mobile
electronics, set up and install this product.
NEVER SERVICE THIS PRODUCT YOURSELF.
Installing or servicing this product and its
connecting cables may expose you to the
risk of electric shock or other hazards, and
can cause damage to this product that is
not covered by warranty.
Precautions before
connecting the system
CAUTION
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not directly connect the yellow lead of
this product to the vehicle battery. If the
lead is directly connected to the battery,
engine vibration may eventually cause
the insulation to fail at the point where
the wire passes from the passenger
compartment into the engine
compartment. If the yellow lead's
insulation tears as a result of contact with
metal parts, short-circuiting can occur,
resulting in considerable danger.
• It is extremely dangerous to allow cables
to become wound around the steering
column or shift lever. Be sure to install
this product, its cables, and wiring away
in such so that they will not obstruct or
hinder driving.
• Make sure that the cables and wires will
not interfere with or become caught in
any of the vehicle's moving parts,
especially the steering wheel, shift lever,
parking brake, sliding seat tracks, doors,
or any of the vehicle's controls.
• Do not route wires where they will be
exposed to high temperatures. If the
insulation heats up, wires may become
damaged, resulting in a short circuit or
malfunction and permanent damage to
the product.
• Do not shorten any leads. If you do, the
protection circuit (fuse holder, fuse
resistor or filter, etc.) may fail to work
properly.
• Never feed power to other electronic
products by cutting the insulation of the
power supply lead of this product and
tapping into the lead. The current
En
9