Publicité
Les langues disponibles
Les langues disponibles
Monitor cover
Machine screw (2 mm × 4 mm)
NOTES
• Do not twist or bend the cables in
excess when securing the monitor
cables to the hook on the back of the
LCD screen.
• Be careful not to lose the small screws
(2 mm × 4 mm) for attaching the
monitor cover.
• It is recommended that you use a
magnetic screwdriver when attaching
the monitor cover.
• Two spare screws (2 mm × 4 mm) for
attaching the monitor cover are
included.
• When attaching the monitor cover
( ), tilt the LCD screen moderately
toward the front to facilitate
installation.
▶Modular style installation
Installation tips
The following procedure describes how to
use the supplied parts to install this
product with the LCD screen attached to
the unit. It is also possible to install this
product so that the LCD screen is separate
from the unit. For details, visit the Pioneer
website for your region.
Depending on the vehicle or installation
location, you may need to adjust the
mounting up-down position of the LCD
screen. For details on the available
mounting LCD screen positions, refer to
The adjusting position of the display for
modular style installation (page 23) before
installing.
For some types of vehicles, it is necessary
to use an installation kit (sold separately)
when installing. For details, contact an
authorized Pioneer dealer or installer for
more information.
1
Remove the front panel from the unit
by removing the screws on the front
edge of the unit.
Front panel
Binding head screw (4 mm × 6 mm)
NOTE
Do not use the screws removed in this step
to mount other parts.
2
Attach the supplied front bracket to
the unit by inserting the pawls of the
bracket into the pawl slots of the unit
and tightening the screws.
Front bracket
Binding head screw (4 mm × 5 mm)
NOTE
Be careful not to be injured by the front
bracket when handling it.
3
Detach the monitor cover from the
LCD screen (
), then connect the
monitor cables to the LCD screen (
After that, attach the LCD screen with
adjusting the up-down position (
)
to this unit by using the screws each
side (
).
CAUTION
Insert the connector with the connector
projection (
) side facing up. If you force
to insert the connector in upside down, it
may be broken.
Monitor cover
Binding head screw (4 mm × 12 mm)
NOTES
• Secure the monitor cables to the
hooks on the back of the LCD screen
so that the cables do not protrude
from the unit. If the cables protrude
from the unit, the cables are pinched
between the vehicle and the unit and
it may prevent installation.
• Do not twist or bend the cables in
excess when securing the monitor
cables to the hook on the back of the
LCD screen.
• Be careful not to pinch the cables
between the front bracket and LCD
screen.
4
Fasten this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
).
of the bracket, and tighten the screws at
three locations on each side.
Use either the binding head screws or
flush surface screws, depending on the
shape of the bracket's screw holes.
TIP
The amount of this unit's protrusion from
the dashboard/console can be adjusted by
shifting the position of the screw hole of
this unit to the factory radio-mounting
bracket.
17
En
Publicité
