Ryobi RY18BPSB Manuel D'utilisation page 6

■ After each use, clean the product as prescribed in this
manual.
CLEANING THE REFILLABLE CONTAINER
Drain all chemical solutions from the refi llable container
into a container approved for chemicals. Do not store the
chemicals in the refi llable container. Use clean water to
clean and rinse the refi llable container. A small amount
of mild household detergent may be added. It may be
necessary to rinse the refi llable container more than once.
CLEANING THE PRODUCT
Do not use fl ammable solvents or abrasive cleaning agents
to clean the product.
1. Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
2. Spray into a suitable container until the tank has been
emptied.
3. Refill and repeat the procedure with clean water. It may
be necessary to rinse the tank more than once, then
drain again as directed above.
4. Allow all parts to completely dry, then reinstall the tank cap.
5. Wipe the outside of the fogger with a clean, dry cloth.
DISPOSAL
■ Never dispose of residual chemicals or contaminated
rinsing solutions in waterways, drains, sewers, street
gutters, or manholes.
■ Dispose of residual chemicals, contaminated rinse
water, and used containers in accordance with local
waste disposal regulations.
TRANSPORTATION AND STORAGE
■ Ensure that all parts are clean and dry. Follow the
procedure described in this manual.
■ Stop the product and remove the battery pack before
storing or transporting.
■ For transportation, secure the product against movement
or falling to prevent injury to persons or damage to the
product.
■ Store the product in a cool, dry, and well-ventilated area
that is inaccessible to children. Keep the product away
from corrosive agents such as garden chemicals and de-
icing salts. Do not store the product outdoors.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
KNOW YOUR PRODUCT
See page 133.
1. Hang tag
2. Hose
3. Trigger
4. Lock-on latch
5. Spray wand
6
Original Instructions
6. Tank
7. Shoulder strap
8. Battery door
9. Elbow
10. On/off adjustment switch
11. Handle cap
12. Basket filter
13. Operator's manual
14. Cone spray nozzle
15. Flat fan nozzle
16. Battery pack
17. Charger
SAFETY DEVICES
TRIGGER WITH LOCK-ON LATCH
Squeezing the trigger releases a stream of spray solution for
spraying consumer grade home and garden chemicals. The
lock-on latch enables continuous spraying without holding
down the nozzle.
ADJUSTMENT SWITCH
The adjustment switch is easily accessible while wearing
the product to turn the product on or off and also adjust the
fl ow rate.
PRESSURE PROTECT SWITCH
The pressure protect switch turns off the product when
the maximum pressure is reached. The motor pump stops
working.
BATTERY COVER
The battery cover protects the battery from exposure to
liquids.
HOUSING DRAINAGE
The housing drainage prevents short circuits that may result
from water leakages.
SYMBOLS ON THE PRODUCT
Safety alert
Read and understand all instructions
before operating the product. Follow
all warnings and safety instructions.
European Conformity Mark
EurAsian Conformity Mark
Ukraine Conformity Mark
British Conformity Mark
Wear eye protection.