Bestway Lay-Z-Spa Instructions D'installation page 8

Assembly for Oval Pool(#54090)
WARNING:TO AVOID THE RISK OF INJURY, DO NOT SIT, CLIMB
OR STAND ON THE SIDE TABLE.
1.Spread out the spa and leatheroid cover and make sure both are right side up.
2.Take a minute to become familiar with the accessories.
3
Beam
3. Install the side beams by inserting one of the beams into the pole sleeve on the side of the spa. Be sure to line up the holes on the sleeve
with the holes on the beam. Repeat this step on the opposite side of the spa.
4. Connect the inflation hose to adapter A on the pump.
5. As previously outlined, test the pump's RCD/PRCD plug and press the Lay-Z-Massage button to activate the pump.
Using the SID-Valve
Screw the SID-Valve onto the air
intake valve.
6-1
7-1
Pole Support Sleeve
6. Using the inflation hose, inflate the spa chambers according to the printed number 1, 2, 3, 4, 5.
7. Insert the U-Supports through the pool support sleeve at the bottom of the spa, insert the two ends of the
U-Supports into the exposed holes on the beam and ensure the spring-loaded pins snap into position. Repeat
this step on the opposite side of the spa.
All manuals and user guides at all-guides.com
4
Open the top cover of the
SID-Valve, insert the inflation
hose and inflate.
6-2
7-2
6
1
2
2
3
4
5
5
Once inflation is finished, fasten
the top cover of the SID-Valve.
6-3
5
Top Leatheroid Cover
NO. NAME
QTY.
1 Table 2
2 Clip B 4
3 Clip A 4
4 Locking pin
8
5 Table Support
4
6 U-support
2
6 7 Beam
2
7
To deflate simply unscrew the
SID-Valve counter clockwise from
the air intake valve.
S-S-000830