Bestway Lay-Z-Spa Instructions D'installation page 7

Assembly for Round Pool(#54075)
2
1. Spread out the spa and leatheroid cover and make sure both are right side up.
2. Connect the inflation hose to adapter A on the pump.
3. As previously outlined, test the pump's RCD/PRCD plug and press the Lay-Z-Massage button to activate the pump.
Using the SID-Valve
Screw the SID-Valve onto the air
intake valve.
4-1
4. Using the inflation hose, inflate the chambers according to the printed numbers 1, 2, 3, 4, 5.
5. Connect the pump to the spa by lining up the matching letters (A to A,B to B and C to C), and using the adapters
to connect the pump to the spa. Ensure the seals are properly in place and hand tighten the adapters securely.
6. Fill the spa using a garden hose. Fill the spa minimum water level to the water level printed on the spa wall.
7. Place the top leatheroid cover over the spa and zip it closed.
5
C C
A
A
B B
WARNING: This spa cover is not a substitute for adult supervision; children must be supervised at all times around the spa.
WARNING: Do not run the Lay-Z-Massage system when the cover is attached, air can accumulate inside the spa and cause irreparable
damage and bodily harm.
All manuals and user guides at all-guides.com
Open the top cover of the
SID-Valve, insert the inflation
hose and inflate.
4-2
6
3
Once inflation is finished, fasten
the top cover of the SID-Valve.
4-3
Top Leatheroid Cover
7
5
To deflate simply unscrew the
SID-Valve counter clockwise from
the air intake valve.
5
S-S-000830