Bestway Lay-Z-Spa Instructions D'installation page 12

Maintaining Spa Water
Poor water quality can be extremenly hazardous to your health. We recommend you do the following things:
A: Clean filter every day and change filter every two weeks depending on use.
B: Change water every few days or use appropriate spa pool chemicals.
All spas require the use of pool chemicals. Please consult your local pool supply retailer for more information about chemical maintenance. Pay
close attention to the chemical manufacturer's instructions. Spa damage resulting from misuse of chemicals and mismanagement of spa water
is not covered by the warranty.
1. Water Balance
We recommend to maintain your water pH between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free
chlorine between 3 to 5ppm. Purchase a test kit to test your water chemistry before each using of the spa, no less
than once per week. Low pH will damage to the spa and pump. Damage resulting from chemical imbalance is
not covered by the warranty.
2. Water Sanitation
Water Sanitation is the responsibility of the spa owner, and should be maintained through the regular and periodic (daily, if necessary)
addition of approved sanitizer. The sanitizer will chemically control the bacteria and viruses
present in the spa water that are caused during use of the spa.
Draining the Spa
1
1. In order to prevent water from escaping,insert the three stopper caps onto the spa's inside adapter and skimmers.
2. Disconnect the pump from the spa.
3. Connect the hose adapter to your garden hose and attach the hose adapter to the spa's B adapter.
4. With your hose positioned in a selected drain area, remove the lower stopper cap from inside the spa to release the water. Once the spa
water has been drained below the spa's bottom air chamber, unscrew the SID- Valve counter clockwise from it's base to deflate the
chamber, doing this will allow the spa water to be drained thoroughly.
Cleaning the spa
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the spa's water.
To clean the spa, use soap and water then rinse.
NOTE: DO NOT use hard brushes or abrasive cleaners.
Spa Repair
If the Spa is torn or punctured, use the provided Repair Patch.
1. Dry the area to be repaired.
2. Remove the patch backing and place the patch over the damaged area.
3. Smooth the surface to remove any air bubbles. A secure unnoticeable repair can usually be made.
Lay-Z-Spa Storage
Make sure all water is drained from the spa and pump. This is essential to extend the life of the spa. We recommend the use of a wet/dry vacuum
to blow out or suck up water from the spa pipes and pump lines. Remove the filter cartridge. It is recommended you store the spa in its original
package in a warm dry place.
NOTE: Plastic becomes brittle and susceptible to breaking when exposed to subzero temperatures. Freezing can severely damage the spa.
Improper winterization of your spa can void your warranty.
All manuals and user guides at all-guides.com
2
10
3 4
S-S-000830