Bestway Lay-Z-Spa Instructions D'installation page 6

Selected Location
WARNING: The selected location has to be capable of supporting the expected load.
WARNING: An adequate drainage system has to be provided to deal with overflow water.
IMPORTANT: Because of the combined weight of the Lay-Z-Spa, water, and users, it is extremely important that the base where the Lay-Z-Spa
is installed is smooth, flat, level and capable of uniformly supporting this weight for the entire time the Lay-Z-Spa is installed. If the Lay-Z-Spa is
placed on a surface, which does not meet these requirements, any damage caused by improper support is not covered under the
manufacturer's warranty. It is the responsibility of the Lay-Z-Spa owner to assure the integrity of the site at all times.
1. Indoors Installation: Be aware of special requirements if you install the spa indoors.
• The floor must be able to withstand the capacity of the Lay-Z-Spa. The floor should be a non-slip, level surface.
• Proper drainage is essential for indoor spa installation. When building a new room for the spa it is recommended
that a floor drain be installed.
• Humidity is a natural side effect with Lay-Z-Spa installation. Determine the effects of airborne moisture on exposed
wood, paper, etc. in the proposed location. To minimize these effects it is best to provide plenty of ventilation to
the selected area. An architect can help determine if more ventilation is needed.
NOTE: Do not install the Lay-Z-Spa on carpet or other material that can be damaged by moisture.
2. Outdoor Installation
• No matter where you install the Lay-Z-Spa, it is important you have a solid support foundation. If you are installing
the Lay-Z-Spa in an outdoor area, ensure there are no sharp objects that could damage it and that the location is
level so the Lay-Z-Spa sits properly.
• During filling, draining or when in use, water may spill out of the spa. Therefore the Lay-Z-Spa should be installed
near a floor drain.
• Do not leave the spa's surface exposed to direct sunlight for long periods of time.
WARNING: TO AVOID ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS RAINING.
Connect the pump to a residential power supply following the provided two methods:
RCD Test
A
WARNING: RISK OF ELECTRIC SHOCK. The RCD plug must be tested before each use.
WARNING: Insert the RCD plug into a residual current device (RCD) protected power outlet only.
WARNING: Before inserting the plug into a power outlet, make sure the current rate of the power outlet and the fixed wiring are suitable for the
pump. Contact a qualified electrician if you cannot verify.
WARNING: Do not use if the above test fails.
PRCD Test
A
RESET
TEST
WARNING: RISK OF ELECTRIC SHOCK. The PRCD plug must be tested before each use.
WARNING: Insert the plug into a residual current device (RCD) protected power outlet only.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the power outlet and the fixed wiring are suitable for the pump.
WARNING: Do not use the pump if this test fails.
All manuals and user guides at all-guides.com
B
T T
RESET RESET
B
RESET
TEST
A. Insert the plug into the power outlet.
C D
T
B. Press the "RESET"button, the indicator
RESET
C. Press the "TEST" button, the indicator
D. Press the "RESET" button, the indicator
A. Insert the plug into a grounded socket.
C D
B. Press the "RESET" button, The indicator
C. Press the "TEST" button, The indicator
D. Press the "RESET" button, the indicator
RESET
TEST
4
light turns red.
light turns off.
light turns red, the pump is ready for use.
light turns red.
light turns off.
light turns red. The pump is ready to use.
S-S-000830