Bestway Lay-Z-Spa Instructions D'installation page 13

Bestway strives to provide the most trouble-free Spas on the market. If you experience any problems whatsoever, do not hesitate to contact
Bestway or your authorized dealer.
Here are some helpful tips to help you to diagnose and rectify some common sources of trouble.
Problems
Pump does not operate
Pump not heating properly
Lay-Z-Massage System does not work
Water Filtration not working
Adapter leakage
Pump adapters are not level with the spa
adapters
Spa leakage
Water not clean
Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain,
damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposals at least free of
charge.
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Probable Causes
-Power failure
-RCD/PRCD tripped
-RCD/PRCD broken
-Temperature set too low
-Dirty Filter Cartridge
-Improper water levels
-Forget to remove the 3 Stopper Caps
-Heating element failed
-Pump is too hot
-30-minute auto shut off feature activated
-Something is wrong with the Pump
-Did not bleed the air purge valve before
operating the pump
-Dirty Filter Cartridge
-Adapter Seal not in right position
-One characteristic of PVC is that it changes
shape, which is normal
-Spa is torn or punctured
-Insufficient filtering time
-Dirty Filter Cartridge
-Improper water maintenance
DISPOSAL
11
Solutions
-Check power source
-Reset RCD/PRCD and check if the home fixed wiring is too thin to
handle 2050W.
-Call for service if it does not reset
-Set to a higher temperature
-Clean/replace the Filter Cartridge in time
-Add water to specified levels
-Remember to remove the 3 Stopper Caps before heating
-Call for service
-Unplug the Pump. After the Pump has cooled insert the plug and
press the Lay-Z-Massage Button to activate
-Press the Lay-Z-Massage Button to reactivate
-Call for service if it does not reset
-Bleed the air purge valve
-Clean/replace the Filter Cartridge in time
-Replace the seal and check
-Elevate the pump with wood or another type of insulated material to
bring the pump's adapters level with the spa's adapters.
-Use provided Repair Patch
-Increase filtration time
-Clean/replace the Filter Cartridge
-Refer to the chemical manufacturer's instructions
S-S-000830