Vimar Elvox EKKO ART 200D Manuel Pour Le Raccordement Et L'emploi page 14

A -
CONTROL PANEL FEATURES
J2
J9
J10
J8
J7
S3
12
All manuals and user guides at all-guides.com
J1 F1
J3
TRANSFORMER
J4
FUSE 1
J5
J6
TR3
TR1 TR2
J1 N F Power supply 230 Vac 50/60 Hz - external to the
control panel - (120 V / 60 Hz upon request)
COM. Common contact
J2
CLOSE Closing impulse contact (NA)
OPEN Opening impulse contact (NA)
STOP STOP impulse contact (NC)
AERIAL Radio Antenna
J3 SIGNAL Gate open state and battery state output
indicator (24 Vdc 3 W max)
A+TEST + 24 Vdc safety strip self-test power supply
EDGE N.C. Safety strip contact (NC)
COM. Common contact
PHOTO N.C. Photocells contact (NC)
K BUTT. Single pulse contact (NO)
PED. BUTT. Pedestrian opening contact (NA)
A+ + 24 Vdc accessories power supply
A - - 24 Vdc accessories power supply
LOCK Electric lock connection (MAX 15 W 12 V)
- 24 Vdc blinker (code ELA2) power
supply. Pay attention to the polarity.
SECONDARY Connection to secondary coil of transformer
J4
18 Vac
TRANSFORMER
J5 MOTOR 1 MOTOR 1 CONNECTION (without polarity)
MOTOR 2 MOTOR 2 CONNECTION (without polarity)
J6
J7 SW T2 24 V Connector dedicated to the factory
programming.
DO NOT REMOVE ANY JUMPER!
OTHERWISE THE OPERATOR WILL NOT
WORK!
Connector dedicated to the factory
J8
SW RADIO
programming
DO NOT REMOVE ANY JUMPER!
OTHERWISE THE OPERATOR WILL NOT
WORK!
RADIO
Built-in radio module
J9
BATTERY
J10 Connector for charge card of 24 Vdc battery
CHARGER
(code ECB4)
TRIMMER RUN
TR1 Trimmer for high speed adjustment operations
TRIMMER
Trimmer for low speed adjustment operations
TR2
LOW SPEED
TRIMMER TCA
TR3 Trimmer for automatic closing time adjustment
(DISABLED DEFAULT AND DL6 LED OFF)
PROG
S3 Programming button
T 8A
Motor protection fuse
FUSE 1
T 2A
Transformer protection fuse
F1
EN