• To switch the tool off, release the switch.
Hints for optimum use
Drilling
• Always apply a light pressure in a
straight line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Use spade bits when drilling large
diameter holes in wood.
• Use HSS drill bits when drilling in metal.
• Use masonry bits when drilling in soft
masonry.
• Use a lubricant when drilling metals
other than cast iron and brass.
• Make an indentation using a centre
punch at the centre of the hole to be
drilled in order to improve accuracy.
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are diffi cult to tighten, try
applying a small amount of washing
liquid or soap as a lubricant.
• Always hold the tool and screwdriver bit
in a straight line with the screw
Troubleshooting
Problem
Possible cause
Unit will not
Battery pack not
start.
charged.
Charger not
Battery pack
plugged in.
will not charge.
Surrounding air
temperature too
hot or too cold.
All manuals and user guides at all-guides.com
Possible solution
Check battery pack
charging requirements
Plug charger into
a working outlet.
Move charger and
battery pack to a
surrounding air
temperature of above
40 degrees F (45 °C)
or below 105 degrees
F (+40.5 °C)
(Original instructions)
Battery pack
Unit shuts off
has reached its
abruptly.
maximum thermal
limit.
Out of charge. (To
maximize the life
of the battery pack
it is designed to
shutoff abruptly
when the charge is
depleted
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, remove the battery
from the tool. Unplug the charger before
cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Batteries
There are no user servicable parts
inside.
• At the end of your products life return the
whole unit to your service agent or to a
local recycling station to have the battery
recycled. Do not throw the unit out with
household waste.
ENGLISH
Allow battery pack
to cool down.
Place on charger
and allow to
charge.
9