Télécharger Imprimer la page

Black & Decker BDCDD12 Traduction Des Instructions Initiales page 7

Publicité

Les langues disponibles

Les langues disponibles

Additional safety instructions for
batteries and chargers (Not
provided with the tool)
Batteries
• Never attempt to open for any reason.
• Do not expose the battery to water.
• Do not store in locations where the
temperature may exceed 40 °C.
• Charge only at ambient temperatures
between 10 °C and 40 °C.
• Charge only using the charger provided
with the tool.
• When disposing of batteries, follow the
instructions given in the section
"Protecting the environment".
Do not attempt to charge damaged
batteries.
Chargers
• Use your BLACK+DECKER charger only
to charge the battery in the tool with
which it was supplied. Other batteries
could burst, causing personal injury and
damage.
• Never attempt to charge
non-rechargeable batteries.
• Have defective cords replaced
immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor
use only.
Read the instruction manual before
use.
Electrical safety
Your charger is double insulated;
therefore no earth wire is required.
Always check that the mains voltage
corresponds to the voltage on the
rating plate. Never attempt to
replace the charger unit with a
regular mains plug.
All manuals and user guides at all-guides.com
(Original instructions)
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the
following features.
1. Variable speedswitch
2. Forward/reverse slider
3. Torque adjustment collar
4. Keyless chuck
5. Battery
6. Battery release button
7. Charger
Assembly
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery (fig. A)
The battery needs to be charged before fi rst
use and whenever it fails to produce su
cient power on jobs that were easily done
before. The battery may become warm while
charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or above
40 °C. Recommended charging temperature:
approx. 24 °C.
Note: The charger will not charge a battery
if the cell temperature is below
approximately 10 °C or above 40 °C. The
battery should be left in the charger and
the charger will begin to charge
automatically when the cell temperature
warms up or cools down.
• Plug the charger (8) into any standard
230 Volts 50 Hz electrical outlet.
• Slide the battery pack into the charger as
shown in fi gure A.
• The green LED (9) will fl ash indicating
that the battery is being charged.
ENGLISH
7

Publicité

loading