Black & Decker BDCDD12 Traduction Des Instructions Initiales page 8

ENGLISH
• The completion of charge is indicated by
the green LED remaining on
continuously. The pack is fully charged
and may be used at this time or left on
the charger.
Warning! Do not use tool while it is
connected to the charger.
Warning! Fire hazard. When disconnecting
the charger from the tool, be sure to unplug
the charger from the outlet fi rst, then
disconnect the charger cord from the tool.
Installing and removing the battery pack
from the tool (fig. B)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery. To install
battery pack:
• Insert battery pack into tool, until an
audible click is heard (fig. B)
Removing the battery pack from the tool
(fig. C)
• Depress the battery release button as
shown in (fig. C) and pull battery pack
out of tool.
Operating Instructions
Trigger switch & reversing button (fig. D)
• The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the
higher the speed of the drill operates at
• A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
• To select forward rotation, release the
trigger switch and depress the
forward/reverse control button to the
left.
• To select reverse, depress the forward/
reverse control button the opposite
direction.
• To lock the tool, set the forward/reverse
slider into the centre position.
Note! The center position of the control
button locks the tool in the off position.
When changing the position of the control
button, be sure the trigger is released.
8
All manuals and user guides at all-guides.com
(Original instructions)
Torque control (fig. E)
This tool is fi tted with a torque adjustment
collar (3) to select the operating mode and
to set the torque for tightening screws.
Large screws and hard workpiece materials
require a higher torque setting than small
screws and soft workpiece materials.
• For drilling, set the collar to the drilling
position symbol .
• For screwdriving, set the collar to the
desired setting. If you do not yet know
the appropriate setting, proceed as
follows:
- Set the collar to the lowest torque setting.
- Tighten the fi rst screw.
- If the clutch ratchets before the desired
result is achieved, increase the collar
setting and continue tightening the screw.
Repeat until you reach the correct
setting. Use this setting for the remaining
screws
Keyless chuck (fig. F)
Warning! Make certain the lock-off button is
engaged to prevent switch actuation before
installing or removing accessories. To insert
a drill bit or other accessory:
• Grasp the rear half of the chuck (10) with
one hand and use your other hand to
rotate the front half (11) in the
counterclockwise direction, as viewed
from the chuck end.
• Insert the bit or other accessory fully into
the chuck, and tighten securely by
holding the rear half of the chuck and
rotating the front portion in the clockwise
direction as viewed from the chuck end.
Warning! Do not attempt to tighten drill bits
(or any other accessory) by gripping the
front part of the chuck and turning the tool
on. Damage to the chuck and personal injury
may occur when changing accessories.
Drilling/screwdriving
• Select forward or reverse rotation using
the forward/reverse slider (2).
• To switch the tool on, press the switch (1).
The tool speed depends on how far you
press the switch.