Publicité
Les langues disponibles
Les langues disponibles
9. INSTALL THE ADAPTER (INTERIOR BLOWER)
Using two (2) standard 1/2'' screws, secure the adapter to the top (or back) of the hood. Seal the adapter
to the hood using duct tape.
HD0005
10. INSTALL THE HOOD (INTERIOR & EXTERIOR BLOWER)
INTERIOR BLOWER: Run power cable to installation location. Place the hood to its location. Mark the position
of the screws (smaller part of the key holes) with a pen. Remove the hood and install the (8) 1/2" double
thread screws leaving a 1/8" gap (4 screws for 30" hood). Remove wiring cover, place the wire clamp, insert
the cable in the hood and tighten the wire clamp to secure the cable. Place the hood under the cabinet
and slide it in position. Make sure the adapter/damper assembly enters the ducting. Secure the hood by
tightening the screws completely.
HD0043
EXTERIOR BLOWER: Run power cable to installation location. Place the hood to its location. Mark the
position of the screws (smaller part of the key holes) with a pen. Remove the hood and install the (8) 1/2"
double thread screws leaving a 1/8" gap (4 screws for 30" hood). Remove wiring cover on top of the hood
and connect wiring (see instructions included with exterior blower). Place the hood under the cabinet and
slide it in position. Secure the hood by tightening the screws completely.
All manuals and user guides at all-guides.com
- 7 -
HD0006
Publicité
