Proper Use; Device Description - ALFRA TMH 50 Mode D'emploi

pROpeR use

The TMH 50 is a hand-operated permanent lifting magnet designed to lift ferromagnetic, metallic loads.
It may only be used according to its technical data and determination. Proper use includes adherence to the
start-up, operating, environment and maintenance conditions specified by the manufacturer. The user bears
sole responsibility for understanding the operating manual as well as for proper use and maintenance of
the lifting magnet.

device descRipTiOn

The TMH50 (Thin Material Handlifter) is a switchable lifting magnet with manual actuation designed to lift
and transport ferromagnetic materials. To activate the magnet, push the activation lever (A) into the ON
position until it audibly latches into place. The installed permanent magnet (B) generates a magnetic field
in the lower magnetic plate area (D). Owing to the special design of the TMH 50, this magnetic field is very
compact and develops excellent adhesive force especially on thin materials of less than 10 mm.
The activation lever must be lifted slightly at its end and returned by 60° into the OFF position in order to
deactivate the magnet.Care must be taken that the lever springs back when working on thin materials.
A stable carrying handle (C) made of aluminium can be found on the upper side of the hand-operated lifting
magnet. The load-bearing capacity of the lifting magnet is equivalent to at least 1/3 of the maximum pull-off
strength of the magnet.
!
Be sure to read the operation instructions completely before using the magnet for the first time!
12
A) Activation lever
B) TMC 300 Magnetic base
(41100)
C) Carrying handle
D) Magnetic surface