Polaris PROPSPECTOR Manuel D'utilisation page 34

WINTER ATV "PROSPECTOR" TRACK KIT
KIT PN 2876001
SECTION 3 : ADJUSTMENTS
3.1. Front Anti-Rotation
1. No adjustments required for initial installation.
WARNING
Adjustments should be made by a dealer or a
competent mechanic.
WARNING
These adjustments should be made on hardened
snow surface.
2. To replace components of the anti-rotation assembly
following these steps :
2.1. Park ATV on a flat surface.
2.2. Loosen the jam nut on the ball joint.
2.3. Screw or unscrew the sliding rod using the
notches intended for this purpose, to facilitate
the turns (screwing will lower the front of the
track and make turning easier; unscrewing will
raise the front of the track and make turning
more difficult).
NOTE : A good initial adjustment is to set the distance
between the external wheel and the main axle
to 2-5/16". Use a carpenter square to set this
distance.
Figure 9 - Front track initial adjustment
2510237
A-2510237 (F-Polaris)
WARNING
Make sure that the handlebars are not turning by
themselves during braking or turning attempts. If it
is the case, the handlebars could suddenly move
when you do not expect and you can get ejected
from the vehicle. Serious injury may result.
2.4. Tighten the jam nut on the ball joint.
3.2. Rear Anti-Rotation
1. Following the initial assembly of the rear anti-
rotation components, place the ATV on a flat
surface on its four tracks.
2. Tighten the adjustments nuts on both sides of the
rubber bushings in a way to slightly press the rubber
bushings against the sub-table.
3. Tighten the nuts until they rest on the ends of the
spacer socket.
WARNING
The nuts must be equally tightened on the rubber
bushings so that both middle wheels of the
assembled Track Kit always stay in contact with the
ground when the vehicle is resting on a flat surface.
- 15 -